Fuel Filter Replacement - VM Motori D700 Série Manuel D'instructions

11- Check that the oil level is correct and top
up if necessary.
When topping up the oil, to avoid exceeding
the maximum allowed value, add the oil in
small amounts (100 to 200 ml at a time) until
it reaches the correct level.
Important
The oil level must be between the mini-
mum and maximum marks on the dipstick.
12- Check for any oil leaks

FUEL FILTER REPLACEMENT

Follow the procedure below.
1- Turn off the engine and remove
the ignition key.
2 - Let the engine cool down ade-
quately to avoid being burnt.
3 - Prepare a container to collect
any leak.
4 - Remove the filter (Z) using the
tool provided.
GB
5 - Fill the new filter with the fuel
from the filter being replaced.
6 - Lubricate the gasket of the new
filter before mounting it.
7 - Fit the new filter using the tool provided.
8 - Bleed air from the fuel supply circuit
(See "Fuel supply circuit bleeding").
9 - Turn the engine on and check for any
fuel leaks.
English
Warning - Caution
In the event of oil leaks, check the level
periodically to evaluate the extent of the
leak. If the amount is excessive, contact
one of the manufacturer's authorised
service centres.
Important
Do not throw away any polluting material
in the environment. Carry out their dis-
posal in compliance with the relevant
legislation in force.
Warning - Caution
In the event of fuel leaks, identify and elimi-
nate the cause.
If the problem persists, contact one of the
manufacturer's authorised service centres.
Important
Do not throw away any polluting material
in the environment. Carry out their dis-
posal in compliance with the relevant
legislation in force.
- 52 -
D700/750 E2-E3
(Z)
Fuel filter
IDM-45300901700.tif
Maintenance information