VM Motori D700 Série Manuel D'instructions page 100

Frequency (1)
Every 150
hours
Every 300
(6)
hours
Every 500
hours
Every 1000
hours
Every 4000
hours
Every 8000
hours
(1) If an hour counter is not available, the frequency of the interventions should be calculated on the basis of a calendar
day: one calendar day corresponds to 12 hours of operation.
(2) In severe working conditions, such as dusty environments and operation at extreme loads, the engine oil must be
changed every 150 working hours. If the engine has not been in operation for the length of time indicated, the oil must
still be changed at least once a year.
(3) If the engine has not been in operation for the length of time indicated, the filter must still be changed at least once
every 12 months.
GB
(4) If the engine has not been in operation for the length of time indicated, the fluid must still be changed at least once
every 24 months.
(5) If the engine has not been in operation for the length of time indicated, the belt must still be changed at least once
every 24 months.
(6) In engine D754SE3, TE3, IE3 models with a low capacity oil sump, a special plate is applied on the cover of the
engine valves to indicate that the engine oil and the oil filter must be changed every 200 hours instead of every 300.
English
Component Type of intervention
Checking the ten-
Transmission sion
(5)
belt
Integrity control
(2)
Engine oil Replace
Replace the cartri-
(3)
Oil filter
dge
(3)
Fuel filter Replace
Fuel circuit unions Check tightening
(4)
Coolant Replace
Air filter Replace
Injector setting
Check the pressure
pressure
Preheating glow Check integrity of
plugs components
Transmission
Replace
(5)
belt
Fuel tank Clean
Performing partial
Engine
overhaul
Performing general
Engine
overhaul
Intervention procedures
Tension belts
Replace, if necessary
Apply to an authorised
workshop
Apply to an authorised
workshop
- 38 -
D700/750 E2-E3
Reference
See "How to adjust
the tension of the dri-
ving belt"
See "Belt replace-
ment"
See " Engine oil
change "
See " Oil filter cartri-
dge replacement "
See "Fuel filter repla-
cement"
See "Control screw
tightening and union
sealing"
See " Coolant repla-
cement "
Apply to an authori-
sed workshop
Apply to an authori-
sed workshop
See "
Belt replace-
"
ment
IDM-45300903200.tif
Maintenance information