What If There Are Problems - Beurer BF 100 Body Complete Mode D'emploi

16 What if there are problems?

If the scale detects and error when measuring, the following is displayed.
Display
ERROR:_OVERLOAD The maximum load capacity of 150 kg
LOW_BATTERY
MEMORY_FULL
ERROR:_CONTACT
ERROR:_DATA
No display
No measurement possible
Possible errors
The control unit was not activated
before you stepped on the scale.
Cordless connection between scale
and control unit is interrupted.
The control unit is too far away from
the scale.
The batteries in the scale are flat or
incorrectly inserted.
Incorrect weight measurement
Possible errors
The scale is not zeroed
correctly.
Scale is on carpeting.
40
Cause
was exceeded.
The batteries are almost empty.
30 measurements have been saved.
The electrical resistance between the
electrodes and the sole of your foot is
too high (e.g. if you have tough cal-
luses).
The BIA measurement was success-
ful but the fat percentage is outside
the measurable range (less than 5 %
or greater than 50 %).
The batteries in the control unit are
completely empty.
The batteries in the control unit are
not inserted correctly.
Remedy
Switch on the control unit first before the measurement.
If necessary, wait 30 seconds, then repeat the meas-
urement.
Reinsert the batteries for the scale and the control unit.
Maintain a larger distance from the following electro-
magnetic sources: high-voltage pylons, television or
wireless computer systems, fitness equipment, mobile
phones, weather stations.
Reduce the distance between the scale and control unit;
maximum distance is 2 metres.
Change the batteries (see page 26) and check that they
are inserted the correct way round.
Remedy
Before taking a measurement, activate the scale briefly with your
foot until the
Wait approximately 5 seconds and repeat the measurement. For
your information: because you would normally step onto the scale
immediately, the scale saves the zero point when the scale is swit-
ched off (when the
Place the scale on a level and solid surface.
Stand with your feet as far apart as possible without tipping the
scales.
www.TopSport.com.ua
Remedy
Do not load the unit with over 150 kg.
Replace the batteries (see page 25
and 39).
Transfer the measurements to a PC,
see page 38.
Repeat the measurement barefoot. If
necessary, moisten the soles of your
feet slightly. If necessary, remove the
calluses from the soles of your feet.
Repeat the measurement barefoot
or, if necessary, moisten the soles of
your feet slightly. If necessary, chan-
ge the level of activity that you have
set.
Replace the batteries (see page 26).
Check to ensure that the polarity is
correct (see page 26)
operating status indicator lights up.
operating status indicator goes out).
Beurer BF 100