Changing The Weight Unit; What If There Are Problems; Messages And Errors - Beurer BF 980 Mode D'emploi

4.7 Changing the weight unit

You can change the weight unit either using the "beurer HealthManager Pro" app or directly on the scale:
1. Press and hold the SET button
2. Use the button
lb = pounds, stlb = stones
3. To confirm, press the SET button
4.8 Deactivating Bluetooth
To deactivate Bluetooth
1. Press and hold the SET button
2. Press the SET button
3. Select "oFF" with the
4. To confirm, press the SET button
Note: Please note that the Bluetooth
To reactivate it, set it from "oFF" to "on".

5. WHAT IF THERE ARE PROBLEMS?

5.1 Restarting scale
If it is necessary to restart the scale (e.g. scale software freezes), briefly press the reboot button
case, the power supply is briefly interrupted.
5.2 Resetting the scale to factory settings
To reset the scale to the factory settings, press and hold the SET button
. Press and hold the SET button
6
5.3 Updating scale software
The app will inform you when a new software update is available.
1. Briefly press on the scale to switch it on.
2. Press and hold the
loads it. This may take a few minutes. If the update is successful, "PASS" will be displayed. If the scale is
already up to date with the latest software version "utd" appears.

5.4 Messages and errors

Display
Discrepancy in
weight
PAir
"USE APP" or
flashing
UnSt
for 4 seconds. "unit" appears on the display
5
or button to select the desired weight unit (kg, lb or stlb). kg = kilograms,
2 3
repeatedly until the display
5
and WIFI
®
and WIFI, proceed as follows:
®
for 4 seconds.
5
repeatedly until "on" appears on the display 1.
5
button or the
2
repeatedly until the display
5
and WIFI function is then NO longer possible.
®
until "rSt" appears on the display.
5
button for 15 seconds. The scale automatically checks for an update and down-
3
Cause/remedy
Incorrect zero point (e.g. in the event of a change of location or temperature fluctua-
tion): briefly press on the scale until the current weight is displayed, then remove your
foot so that "0.0" flashes.
Scale is placed on carpet or uneven ground: the surface must be hard and level.
Bluetooth needs to be paired: start/allow pairing/bonding on your smartphone (note
®
any messages in the status bar/notification bar), and confirm the 6-digit pairing code
using the SET button
The scale can be connected to the app via Bluetooth
Bluetooth settings on your smartphone, only via the app.
®
This weight measurement was unstable: stand still during the measurement.
button .
3
on the device and on the smartphone.
5
18
.
1
switches off.
1
switches off.
1
and briefly press the reboot button
5
: do not connect it via the
®
. In this
6