Installing The Control Unit - Beurer BG 64 Mode D'emploi

6

Installing the control unit

Setting up the control unit
You can either hold the control unit in your
hand, set it on a level surface or keep it on
the scale. The black plastic part with the
Beurer logo is a magnetic wall holder for
wall mounting.
Fold out the pedestal as shown in order to
rest the control unit on a level surface.
Wall mounting
Using the mounting kit, you can mount the
control unit on a wall. Use the mounting kit
provided and install the wall holder as
shown.
Drill 2 holes in the wall next to each
other horizontally, spaced 82 mm apart.
Using a 6 mm drill, drill holes in the wall
with a depth of approx. 40 mm. Insert
the wall plugs.
Turn the fastening screws into the wall
plugs, until only about 4 mm of the
screw heads protrude.
Fasten the wall holder, then set the con-
trol unit on the magnetic holder.
Alternative wall mounting method
You can also fasten the wall holder to a
wall using the double-sided adhesive tape.
For this purpose, the wall surface must be
clean and dry.
Remove the protective film from the ad-
hesive tape on the rear side of the wall
holder.
Press the wall holder firmly against the
wall.
23