Beurer BF 980 Mode D'emploi page 19

Display
U: --
BF--
HR--
oLd
BAt / Lo
Err1
Err2
Er3...
Err4
USB out
utd
no
5.5 WIFI/ Bluetooth
Problem
No Bluetooth
®
connection
Symbol is
11
not displayed
Cause/remedy
The scale was unable to assign the measurement to a scale user: if the automatic
scale user detection function is not working, briefly press the scale with your foot,
press the button
onds. Weigh yourself again.
The body fat percentage is outside the measurable range (less than 5% or greater
than 70%): check the user data or change the activity level.
Diagnostic measurement cannot be taken (e.g. measurement attempted while wear-
ing shoes): Repeat the measurement barefoot. Otherwise, only weight values will be
displayed and transferred.
Heart rate measurement not successful: repeat measurement whilst barefoot and
remain standing still from when the weight measurement is being carried out until the
heart rate measurement is complete. Do not step off or move too early.
The maximum weight capacity of 180 kg has been exceeded: loads must not exceed
180 kg.
The scale battery is empty: charge the battery.
Incorrect password for your selected WIFI network/SSID/router.
Your router does not have Internet access. The server cannot be reached.
Software update failed: please try again.
Booting problems: press the Reboot button
Unplug the USB cable.
The software is up to date.
There is no WIFI connection to the server for the software update.
connection problems
®
Cause/remedy
Device is outside the Bluetooth
The minimum range in the open is approx. 10 m. Walls and ceilings reduce the range.
Other radio waves may interfere with the transmission. Therefore, do not position the
scale near devices such as microwaves or induction hobs. Ideally, switch off other
Bluetooth devices that are within range.
®
No Bluetooth connection to the app.
®
1. Press the SET button
Then use the "beurer HealthManager Pro" app.
2. Switch Bluetooth
®
being connected via the Bluetooth
remove it from the device list in the Bluetooth
HealthManager Pro" app.
3. Completely close the app (including in the background). Switch your smartphone
off and on again.
4. Briefly press the reboot button
app.
5. When connecting the scale, check the status bar on the smartphone to start pair-
ing/bonding.
Note: A Bluetooth
®
scale's settings. The measurements can also be transferred via Bluetooth
the normal standard application the measurement data will be transferred via WIFI
(without Bluetooth ).
®
repeatedly until your scale user is displayed, and wait 3 sec-
2
range.
®
on the scale so that "USE APP" flashes in the scale display.
5
on your smartphone off and on again. Ensure that the scale is not
settings of the operating system. If necessary,
®
and then the SET button
6
connection is only required for initial use and changing the
19
briefly.
6
settings and then use the "beurer
®
again and open the
5
, but in
®