Adjusting The Height Of The Leg Support; Using The Leg Band - Invacare ISA Série Manuel D'utilisation

Invacare® ISA™
The following guidelines are based on average values and
deviations can and do occur:
• Position 1 (fully shortened): patient height from about
140 cm and taller.
• Position 5: patient height from about 170 cm and taller.
• Position 9 (fully extended): patient height up to about
200 cm.
IMPORTANT
An individual trial fitting is strongly recommended
to determine a correct and safe setting for each
patient.
1 9
A
6
1 9
1. Push and hold the red lever A on the boom upwards.
2. Adjust the length of the lifting arm B to one of the nine
available positions indicated on the scale C, by placing
the desired position field before the edge of the boom.
3. Release the lever A and slightly move the lifting arm B
back and forth until an audible click is heard and it is
locked into position.
5.6 Adjusting the height of the leg
support
14
B
C
5 4 3 2 1
1. Push and hold the release handle A on the leg support
B upwards.
2. Slide the leg support B up or down.
3. When the desired height is reached, release the handle
A and slightly move the leg support B up or down until
an audible click is heard and the leg support B is locked
into one of the 6 available height positions.

5.7 Using the leg band

1.
To apply the leg band, wrap the long padded part
around the leg support and the patient´s lower legs and
push the catch A into the buckle clasp B on the back
side of the leg support.
2.
To open, press the release mechanism C and pull the
catch A out of the buckle clasp B.
3.
To adjust the length of the leg band, either pull on the
lug A to shorten or push the lug A towards the buckle
to lengthen.
1654371-A