Installing The Foot Plate; Installing The Leg Band; Installing The Leg Support; Installing The Lever For Manual Leg Spreader - Invacare ISA Série Manuel D'utilisation

4.4 Installing the foot plate

1. Lower the foot plate onto the base until the brackets A
are fully seated on tube B.

4.5 Installing the leg band

(optional)
The two parts of the leg band are attached on the back
side of the leg support.
1.
Thread the two hooks A into lugs B on the back side
of the leg support.
2.
Thread the loops C of the two leg band parts into the
hooks A.
1654371-A

4.6 Installing the leg support

1. Push and hold up the release handle A on the leg
support B.
2. Slide the guide bar on the back of the leg support B
onto its mounting plate C on the mast.
3. When the desired height is reached, release the handle
A and slightly move the leg support B up or down until
an audible click is heard and the leg support B is locked
into one of the 6 available height positions.
4.7 Installing the lever for manual leg
spreader
2 x 13 mm wrench
1. Insert the bolt A from below into the lower hole of the
bracket B and fix it with the nut C.
2. Insert the threaded end of lever D into the upper hole
of bracket B onto the fixed bolt A.
3. Turn the lever D clockwise to screw it onto the bolt.
Setup
11