Approved Power Tool Attachments; Mounting The Bike Handle - Stihl FS 120 Notice D'emploi

English
Approved Power Tool
Attachments
STIHL power tool attachments are
available for converting the single
purpose FS unit into other power tool
combinations.
Attachment Application
1)
BF Cultivator
1)
BC 35 Cultivator
1)
Barrier bar must be fitted on the
loop handle
20

Mounting the Bike Handle

Removing Clamp Moldings
:
Hold the lower clamp (1) and upper
clamp (2) firmly.
:
Release the wing screw (3).
The clamps are loose once the wing
screw has been released. They are
pushed apart by the two springs (4
and 5).
:
Pull out the wing screw.
:
Take the washer (6) out of the upper
clamp.
:
Separate the clamps.
Springs (4) and (5) remain in the
lower clamp.
A
7
1
Mounting the Handlebar
:
Place the handlebar (7) in the lower
clamp (1) so that distance A is no
more than 6 in (15 cm).
:
Place the upper clamp in position
and hold both clamps together.
:
Push the wing screw, with washer,
through the two clamps as far as
stop – hold all parts together and
secure them.
FS 120, FS 200, FS 250