Stihl FS 120 Notice D'emploi page 27

English
3
4
5
1
2
:
Pull the hose (1) (protector for
shipping) off the shaft (2).
:
Go to "Mounting the Mowing Head".
If you want to mount a metal cutting
tool in place of a mowing head, you
will need the following additional
parts: Nut (3), rider plate (4) and
thrust washer (5) (special
accessories).
26
Mounting hardware is packed with
the machine
Mowing heads and metal cutting
tools may be mounted.
Mounting hardware is loose
:
Pull the hose (1) (protector for
shipping) off the shaft (2).
The nut (3), rider plate (4) and thrust
washer (5) are in the parts kit
supplied with the machine.
:
Go to "Mounting the Mowing Head"
or "Mounting Metal Cutting Tools".
Mounting hardware is secured to
gearhead
:
Go to "Removing Mounting
Hardware"
Removing Mounting Hardware
:
Block the shaft – see next section
on "Blocking the Output Shaft".
: 1)
Use the combination wrench (6) to
unscrew the nut (3) clockwise (left-
hand thread) from the shaft (2).
:
Pull the thrust washer (5) off the
shaft (2).
1)
Comes standard with the machine or
is available as special accessory
FS 120, FS 200, FS 250