Stihl FS 120 Notice D'emploi page 28

The rider plate (4) is in the parts kit
supplied with the machine.
:
Go to "Mounting the Mowing Head"
or "Mounting Metal Cutting Tools".
Blocking the Output Shaft
2
8
7 7
1)
:
Insert the stop pin or screwdriver
(7) in the hole (8) in the gearhead as
far as stop – apply slight pressure.
:
Rotate nut or cutting tool on the
shaft (2) until the stop pin slips into
position and blocks the shaft.
1)
Comes standard with the machine or
is available as special accessory
FS 120, FS 200, FS 250
1
1)
Mounting the Mowing Head
Keep instruction sheet for mowing head
in a safe place.
:
Screw
STIHL SuperCut 20-2,
STIHL AutoCut 25-2, 30-2,
STIHL TrimCut 30-2 or
STIHL PolyCut 20-3
counterclockwise onto the shaft (1)
as far as stop.
:
Block the output shaft.
:
Tighten down the mowing head
firmly.
Remove the tool used to block the
shaft.
English
5
4
3
1
2
STIHL FixCut 25-2
:
Place the mowing head on the
thrust plate (2).
Collar (arrow) must locate in the
mowing head's mounting hole.
die
:
Push the thrust washer (3) over the
shaft (1) so that it locates against
the base.
:
Block the output shaft.
:
Use the combination wrench (5) to
screw the mounting nut (4) onto the
shaft and tighten it down firmly.
Remove the tool used to block the
shaft.
27