Storing The Machine; Sharpening Metal Cutting Tools - Stihl FS 120 Notice D'emploi

Storing the Machine

For periods of about 3 months or longer
:
Drain and clean the fuel tank in a
well ventilated area.
:
Dispose fuel properly in accordance
with local environmental
requirements.
:
Run engine until carburetor is dry –
this helps prevent carburetor
diaphragms sticking together.
:
Remove, clean and inspect the
cutting tool.
:
Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
:
Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
FS 120, FS 200, FS 250
Sharpening
Metal Cutting Tools
:
Use a file – see "Special
Accessories" – to sharpen cutting
tools. In case of more serious wear
or nicks: Resharpen with a grinder
or have work done by STIHL dealer.
:
Resharpen frequently, take away as
little material as possible – two or
three strokes of the file are usually
enough.
To avoid out-of-balance
:
After resharpening about 5 times,
have blade checked on STIHL
balancer – see "Special
Accessories" – and rebalanced as
necessary.
English
1 1
2
2
1
2
2
1
:
Resharpen the cutters (1) uniformly
– do not alter the contour of the
parent blade (2) in any way.
See cutting tool packaging for additional
sharpening instructions.
43