Replacing Starter Rope And Rewind Spring - Stihl FS 120 Notice D'emploi

Replacing Starter Rope
and Rewind Spring
1 1
1 1
2
3
4
Replacing a Broken Starter Rope
The rewind spring may pop out and
uncoil during this operation. Take
care to avoid injury.
:
Remove the screws (1).
:
Lift away the fan housing.
:
Remove the spring clip (2).
:
Carefully remove the rope rotor with
washer (3) and pawl (4).
FS 120, FS 200, FS 250
5
6
:
Ease the cap (5) out of the starter
grip.
:
Remove remaining rope from the
rotor and grip.
:
Tie a simple overhand knot in the
new rope – see "Specifications" –
and then thread it through the top of
the grip and the rope bush (6).
:
Refit the cap in the grip.
English
2
3
4
:
Thread the rope through the rotor
and secure it with a simple
overhand knot.
:
Coat rope rotor bearing bore with
non-resinous oil – see "Special
Accessories".
:
Slip rotor over starter post – turn it
back and forth to engage anchor
loop of rewind spring.
:
Refit the pawl (4).
:
Fit the washer (3).
:
Install spring clip (2) on starter post
and engage it on the pawl's peg –
the spring clip must point clockwise.
41