Stihl FS 120 Notice D'emploi page 29

Masquer les pouces Voir aussi pour FS 120:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Removing the Mowing Head
:
Block the output shaft.
STIHL SuperCut 20-2,
STIHL AutoCut 25-2, 30-2,
STIHL TrimCut 30-2,
STIHL PolyCut 20-3
:
Unscrew the mowing head
clockwise.
STIHL FixCut 25-2
:
Use the combination wrench to
loosen and unscrew the mounting
nut clockwise from the output shaft.
If the mounting nut is too loose, fit a
new one.
Adjusting Nylon Line
STIHL SuperCut
Fresh line is advanced automatically if
remaining line is still at least 6 cm long.
The blade on the deflector trims over-
long lines to the correct length.
28
STIHL AutoCut
:
Hold the rotating cutting head
horizontal to the ground – tap it on
the ground – about 3 cm fresh line
is advanced.
The blade on the deflector trims over-
long lines to the correct length. Avoid
tapping the head more than once.
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
All other mowing heads
Refer to instructions supplied with the
mowing head.
To reduce the risk of serious injury,
always shut off the engine before
adjusting the mowing line by hand.
Replacing Nylon Line
or Cutting Blades
Refer to instructions supplied with the
mowing head.
1
2
3
4
5
6
Mounting metal cutting tools
The skirt and line limiting blade
are not required for grass cutting
blades 230-2 (1), 230-4 (3), 230-8
(2) or the brush knife (4) – see
"Mounting the Deflector".
Fit the appropriate limit stop for
circular saw blades 200 (5, 6) – see
"Mounting the Deflector".
FS 120, FS 200, FS 250

Hide quick links:

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Fs 200Fs 250

Table des Matières