ELSA LANCOM Business Manuel De L'utilisateur page 272

R96 ELSA LANCOM Business Internal
NetBIOS
IP-Rt.
IP-RIP
ICMP
IP-MASQ
ARP
DHCP
Packet dump
In addition to these parameters there are also the following "group parameters"
(parameters for a specific type of protocol), with whose aid the online trace outputs for
a complete, logically connected protocol family can be activated or deactivated:
All
Display
Protocol
TCP-IP
IPX-SPX
Finally, still more parameters are recognized with which the display format of the trace
outputs can be influenced:
Time
Source
Every trace output is shortened to 21 characters by switching off the prefix outputs
and source
'
Prefix Output 'Time'
By activating the prefix output
the output is generated) in the following form as a prefix:
Format: [days]d; _[hours]:[Minutes]:[Seconds]_
Example:
12t; 07:23:15
corresponds to the system time of twelve days, seven hours, twenty-three minutes and
fifteen seconds.
ELSA LANCOM Business
Display IPX NetBIOS administration
Display IP routing
Display IP routing information protocol
Display Internet control message protocol
Display procedures in masquerading module
Display address resolution protocol
Display Dynamic Host Configuration Protocols (only LANCOM Office -Router)
Display of the 64 bytes of a packet in hexadecimal format (only LANCOM Office -
Router)
Display all online trace outputs
Display 'status' and 'error'
Display 'ELSA', 'PPP' and 'SCRPT'
Display 'IP-Rt.', 'IP-RIP', 'ICMP', 'ARP' and 'IP-MASQ'
Display 'IPX-Rt.', 'RIP', 'SAP', 'IPX-Wd.', 'SPX-Wd.' and 'NetBIOS'
Display the system time as a prefix
Display the generating protocol as a prefix
. The output of the prefixes is activated by default.
'
time
'
every trace output has the system time (at the time
'
time
' '