Setup/Wan-Module - ELSA LANCOM Business Manuel De L'utilisateur

R38 Description of the menu options
/Setup
DHCP-module
NetBIOS-module
Config-module
LANCAPI-module
LCR-module
DNS module
Time-module
Name Here you can enter the device name (maximum 16 characters). The set of characters
available includes uppercase and lowercase letters as well as some special characters.
You can display the full range of available characters during a configuration session by
entering the following command:
set \setup\name ?
In the default configuration, no name is entered.
The device name is required for identification purposes; it is a prerequisite for any
connection via the IPX or IP router module, since the routers can exchange data only with
known remote stations, and is also required for the unambiguous identification of a
remote bridge station.
In the case of PPP connections, either the user name with the password from the PPP list
or the device name is transferred to the remote station as a device ID during a verification
by PAP or CHAP.
In addition, the device names you assign must be unique. For example, you might match
the device names to the location (e.g. Glasgow, London, Provider, etc.).

Setup/WAN-module

This menu groups together all the settings necessary for starting up the WAN interface
and controlling connections to logical remote stations.
/WAN-module
Interface-list
Router-interface-list
Channel-list
Name-list
RoundRobin-list
Layer-list
ELSA LANCOM Business
System configuration
DHCP server settings
Settings for the NetBIOS proxy
Configuration module settings
ELSA LANCAPI settings
Least-cost router settings
DNS server settings
Time module settings
WAN settings
S interface settings
0
Router module settings
Settings for the use of the available channels
Remote station settings
Settings for different remote station numbers
Settings for the layer combinations used