Setup/Config-Module - ELSA LANCOM Business Manuel De L'utilisateur

R74 Description of the menu options
0x0020
0x0040
0x0080
The server list has the following structure:
Host Group/
Domain
REMOTE WORKGROUP 00
WORKSTATION WORKGROUP 07
Unlike the host and group lists, this table fills gradually, as the NetBIOS module depends
on messages from the servers themselves.
The individual fields have the following significance:
Host
Group/Domain
UPD
IP-address
OS-Ver
SMB-Ver
Server-type
Remote station
Timeout
Flags

Setup/Config-module

This menu allows you to enter settings for router configuration options. The menu has
the following layout:
/Config-module
LAN-config
WAN-config
Password-required
Farconfig-(EAZ-MSN)
Maximum-connections
ELSA LANCOM Business
This identifies a remote station.
Reserved
Reserved
UPD IP-address OS-
Ver
10.0.1.100 0400
10.0.0.10 0400
Name of the server
Workgroup or domain in which the server is located.
Update counter: indicates the number of times that the server has already propa-
gated itself
Address of the server
Operating system version number
Version number of the SMB protocol used
Bit mask in which the services of the server are coded
Name of the remote station from which the server was announced
Time until the entry loses its validity (for entries from the LAN) or time until the
router propagates a remote entry.
Corresponds to the flags in the host or group tables.
Configuration module settings
Switch for configuring from the LAN side
Switch for configuring from the WAN side
Password required on/off if there is no password
Subscriber number for remote configuration via PPP
Maximum number of simultaneous connections
SMB- Server- Remote
Ver type station
010f 0004140b GLASGOW
0415 00452003
Time- Flags
out
13 0020
31 0000