hergom Aranda Instructions Pour L'installation, L'utilisation Et L'entretien page 57

Once the oven has been installed, the control element will be attached to the spindle in
one of the four positions using the M-5 nut and bolt.
6.-Draw valve position change
In the case of Aranda and Santacruz on-site insert
models, the valve comes on the right-hand side of
the oven. It is very easy to change the position of
the valve if required to adapt its position to the
location where the oven is to be installed.
Use a Philips screwdriver to remove the eight
screws that hold the head of the valve cover to the
roof of the oven. Once removed, place the valve in
the desired position.
In order to assemble the valve in the desired
position, use a Philips screwdriver to attach the
eight screws accordingly.
7.- Insert
If a built-in chimney already exists, the
said chimney must be connected to the
Fireplace by means of a pipe that perfectly
connects to the flue on the device. (See Fig.- 9)
It is essential to seal the joints between
chimney sections. (See Fig-13).
It is advisable to install grilles for the air
input at the bottom of the lining and an air outlet
at the top of the hood to allow hot air to circulate
inside, (See Fig.- 9) for two main reasons:
- provide extra hot air to the room.
- avoid possible cracks in the lining.
HERGOM provides 25x20 and 50x20 cm.
ornamental grilles that can be supplied as an
option.
5. Brickwork chimney.
6. Pipe connecting Fireplace to
the chimney
7. Inflow of cool air to the lining
8. Outflow of hot air to the room.
Fig. 9
4
57
2
Seal
Fig.-9.
1
Sellar
3