GGP ITALY MC846 Manuel D'utilisation page 36

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
MAINTENANCE AND STORAGE / TROUBLESHOOTING
– Pour a teaspoon of (new) 2-stroke engine oil
into the spark plug slot.
– Pull the starter rope several times to deliver oil
to the cylinder..
– Replace the spark plug with the piston in the
dead end upper position (visible from the
spark plug slot when the piston is at maximum
stroke).
9. TROUBLESHOOTING
PROBLEM
1) The engine will
not start or will not
keep running
2) The engine starts
but is lacking in
power
3) The engine runs
irregularly and lacks
in power when
revved
4) The engine gives
off an excessive
amount of smoke
LIKELY CAUSE
– Incorrect starting procedure
– Dirty spark plug or incorrect distance
between the electrodes
– Air filter clogged
– Carburetion problems
– Air filter clogged
– Carburetion problems
– Dirty spark plug or incorrect distance
between the electrodes
– Carburetion problems
– Incorrect composition
of the fuel mixture
– Carburetion problems
• Restarting work
When you wish to start using the machine again:
– Remove the spark plug.
– Pull the starter rope a few times to eliminate
excess oil.
– Check the spark plug as described in chapter
"Checking the spark plug".
– Prepare the machine as indicated in the para-
graph entitled "Preparing for work".
SOLUTION
– Follow the instructions
(see chapter 6)
– Check the spark plug
(see chapter 8)
– Clean and/or replace the filter
(see chapter 8)
– Contact your dealer
– Clean and/or replace the filter
(see chapter 8)
– Contact your dealer
– Check the spark plug
(see chapter 8)
– Contact your dealer
– Prepare the fuel mixture according
to the instructions (see chap. 5)
– Contact your dealer
15
EN

Publicité

Table des Matières
loading

Table des Matières