Changing The Language - Eaton Powerware Série Guide D'installation

OPERATION
Indicator Status
On
Slow Flash
Green
Fast Flash
Off
On
Slow Flash
Yellow
Fast Flash
On
Slow Flash
Yellow
Slow Flash
Red
Slow Flash
All LEDs
42 ®
Eaton 9140 (9910-E82/E83) UPS Installation Guide for IBM
www.eaton.com/ibm
The following table shows the indicator status and description.
Description
The UPS is operating normally.
The UPS is in Standby mode.
The UPS is starting up.
The UPS is turned off and will not turn on automatically.
The UPS is in Battery mode.
The UPS is in Battery mode and a Low Battery condition is detected.
A battery test is in progress.
The UPS is in Bypass mode.
Bypass mode in unavailable because the input utility is outside the configured
bypass range.
The UPS has an active warning alarm and is supporting the load.
See "Troubleshooting" in the Eaton 9140 UPS (7.5–10 kVA) User's Guide on the
User's Guide CD for additional information.
The UPS is powering down and the load is no longer supported.

Changing the Language

To change the language setting, select MENU from the system status
screen, then select SETUP, USER SETUP, and LANGUAGE. Scroll
through the available options and press the
language.
button to select the
S
®
Applications 164201715 Rev 2