Standby Mode; Ups Startup And Shutdown; Normal Mode Startup - Eaton Powerware Série Guide D'installation

OPERATION

UPS Startup and Shutdown

48 ®
Eaton 9140 (9910-E82/E83) UPS Installation Guide for IBM
www.eaton.com/ibm

Standby Mode

When the UPS is turned off and remains plugged into a power outlet,
the UPS is in Standby mode. The
that power is not available to your equipment. The battery recharges
when necessary.
Only qualified service personnel (such as a licensed electrician) should perform the UPS
installation and initial startup. Risk of electrical shock.
Verify that UPS installation has been carried out correctly and the UPS
ground has been connected.

Normal Mode Startup

NOTE If the UPS detects that utility power is unavailable or out of range, and the DC Start
user setting is enabled, the UPS will automatically start up on battery.
To start up the UPS with utility power connected:
1. Turn off all protected equipment before starting up the UPS.
2. Switch on utility power where the UPS is connected.
3. Wait for the front panel LCD to illuminate.
The LCD displays the startup screen for five seconds, then displays
the system status screen. The fans run. The
quickly then slowly, indicating that the UPS has entered Standby
mode.
4. Switch all output circuit breakers to the ON (
indicator flashes slowly, indicating
W A R N I N G
| ) position.
S
®
Applications 164201715 Rev 2
indicator flashes