Ups Shutdown From Normal Or Bypass Mode; Ups Shutdown From Battery Mode - Eaton Powerware Série Guide D'installation

UPS Shutdown from Normal or Bypass Mode

To shut down the UPS from Normal or Bypass mode:
1. Turn off or remove all protected equipment before turning off or
shutting down the UPS.
2. Select MENU from the system status screen, then select
CONTROL, OUTPUT CONTROL, and UPS TO OFF.
3. Confirm the selection by pressing and holding the
three seconds to select OK.
The LCD displays a confirmation message and the
flashes slowly, indicating that the UPS is no longer supporting the
load and has transfered to Standby mode.
4. To shut down the UPS from Standby mode, unplug or remove utility
power from the UPS.
The UPS powers down, all indicators flash slowly, and the UPS
shuts down completely in approximately 10 seconds.

UPS Shutdown from Battery Mode

To shut down the UPS from Battery mode:
1. Turn off or remove all protected equipment before turning off or
shutting down the UPS.
2. Select MENU from the system status screen, then select
CONTROL, OUTPUT CONTROL, and UPS TO SHUTDOWN.
3. Confirm the selection by pressing and holding the
three seconds to select OK.
The LCD displays a confirmation message and all indicators flash
slowly, indicating that the UPS is powering down and no longer
supporting the load.
The UPS disconnects from the batteries and powers off in
approximately 10 seconds.
®
Eaton 9140 (9910-E82/E83) UPS Installation Guide for IBM
button for
button for
S
®
Applications 164201715 Rev 2
www.eaton.com/ibm
OPERATION
indicator
51