Communication Options; I5, Iseries, Or As/400 And Serial Server Interface Overview - Eaton Powerware Série Guide D'installation

COMMUNICATION

Communication Options

Table 11. Communication Options
Application
IBM i5/iSeries Server
IBM i5/iSeries Server and Serial Server
(Microsoft Windows , Linux
® ®
operating systems)
IBM p5/pSeries Server, OpenPowert, or
xSeries Server with Single Serial (TTY)
®
Connection
IBM p5/pSeries Server, OpenPower, or
xSeries Server with LPARs and/or Network
(WebServer) Connection (UPS as a node)
58 ®
Eaton 9140 (9910-E82/E83) UPS Installation Guide for IBM
www.eaton.com/ibm
If you want the UPS to communicate with your computer, use Figure 35
to determine which communication option is correct for your application.
Software Suite CD
and Serial or USB
, AIX , or other
® ®
Follow the installation instructions with the Software Suite CD or the
applicable card kit. This section shows the communication option
overviews. For additional information and a current listing of supported
operating systems, go to www.eaton.com/ibm.

i5, iSeries, or AS/400 and Serial Server Interface Overview

To connect the UPS to an i5, iSeries, or AS/400
need:
S
An Eaton-supplied Relay/Serial Card, an AS/400 interface cable
(labeled 152601976-001), and a serial interface cable (labeled
124102044-001), located in the FC 2939 carton labeled "Cable Kit for
IBM iSeries and Windows or AIX/Linux Servers"
S
For the i5 only: An IBM-supplied UPS interface cable (labeled 1827),
included with the server
S
For the serial server only: LanSafe Power Management Software
from the Software Suite CD, located in the E82/E83 accessory kit
ConnectUPS-X
Web/SNMP Card Kit
Cable (FC 2934)
— —
— —
X —
— X
S
®
Applications 164201715 Rev 2
Relay/Serial Card
and Cable Kit
(FC 2939)
X
X
—
—
and a serial server you
®