Eaton Powerware Série Guide D'installation page 37

The UPS is heavy (42 kg/92 lb). A minimum of two people are required to remove the UPS
from its carton.
8. Place the UPS on a flat, stable surface with the front of the UPS
facing toward you.
9. Remove the UPS front cover and the electronics module and set
them aside (see Figure 18):
To remove the UPS front cover, loosen the two front cover screws.
Grasp the fingergrips on both sides of the cover and pull the cover
forward firmly.
To remove the electronics module, turn the module lock switch to the
UNLOCK position. Grasp the handle at the bottom of the module
and pull the module slowly out of the cabinet. Use two hands to
support the module.
Figure 18. Removing the UPS Front Cover and Electronics Module
®
Eaton 9140 (9910-E82/E83) UPS Installation Guide for IBM
C A U T I O N
S
®
Applications 164201715 Rev 2
www.eaton.com/ibm
INSTALLATION
21