Display Functions - Eaton Powerware Série Guide D'installation

Table 9. Menu Map for Display Functions
Main Menu Submenu
Control
Output Control
Battery Test
Status Active Alarms
UPS Output
UPS Input
Battery
DC Link
System
Alarm History
Model Info
Setup
User Setup
Service Setup
Eaton

Display Functions

When the UPS starts up, the LCD displays the Eaton logo and the type
of UPS.
About 5 seconds after startup or after 15 minutes of inactivity, the LCD
displays the system status screen. The system status screen shows the
output voltage, output frequency, output load percent, and the current
operating mode (see Figure 33 on page 41).
The backlit LCD automatically dims after a long period of inactivity. Press
any button to restore the screen.
From the system status screen, press the
Use the two middle buttons (
structure. Press the
Press the button to cancel or return to the previous menu.
The following table shows the basic menu structure.
Display Information or Menu Function
Turn the UPS on and off / Transfer to other modes
Cancel a test / Schedule a test / View a test report
Display any active alarms
Display the voltage, current, frequency, load, current, watts, and VA
Display the current utility voltage and frequency
Display the current positive and negative battery voltages, percent battery
charge, and expected battery runtime in minutes
Display the current positive and negative rail voltages
Display the system runtime (days/hrs/min/sec)
Display the most recent 50 events and alarms, by description, alarm
number, and time (day/hr/mins/sec in system runtime).
UPS Type / UPS Serial Number / UPS Part Number / Firmware Version
See Table 10 for detail.
This screen is password-protected.
®
9140 (9910-E82/E83) UPS Installation Guide for IBM
and ) to scroll through the menu
button to select an option or enter a submenu.
®
Applications
www.eaton.com/ibm
OPERATION
button to select MENU.
S
164201715 Rev 2
43