Installing The Ebm Batteries - Eaton Powerware Série Guide D'installation

Installing the EBM Batteries

To install the battery trays into the EBM cabinet (located in the cartons
labeled 9910-E82/E83-6646 Battery Tray, PN 44V3920):
1. Verify that the battery circuit breaker on the EBM rear panel is in
the OFF (O) position (see Figure 25 on page 28).
2. Remove the EBM front cover (see Figure 10).
To remove the front cover, loosen the two front cover screws.
Grasp the fingergrips on both sides of the cover and pull the cover
forward firmly.
3. Slide the battery trays into the cabinet (see Figure 11). Push each
tray in until the battery tray lock on the handle catches to lock the
tray in place.
®
Eaton 9140 (9910-E82/E83) UPS Installation Guide for IBM
Figure 10. Removing the EBM Front Cover
Figure 11. Installing the Battery Trays
®
Applications
INSTALLATION
Battery Tray
Lock
S
164201715 Rev 2
www.eaton.com/ibm
13