Setting up the massage lounger
1) Checking the accessories
●
Armrests (Left/Right)
Left/Right indication
(armrest back)
2) Where to use the unit
Ensure there is adequate space to recline.
●
Unit body dimensions Height approx. 120 cm (47.2 in.) × Width* approx. 85 cm (33.5 in.) × Depth* approx. 200 cm (78.7 in.)
(See EN51 for detailed unit dimensions.)
* When installing near a wall, etc.
In the reclining state, make sure that the backrest and the legrest are away from walls, etc., by 10 cm (3.9 in.)
or more, and the armrest is away from walls, etc., by 5 cm (2.0 in.) or more.
●
Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of heating sources.
This can cause discoloration or hardening of the synthetic leather.
3) Installing
Hold the sides of the legrest.
EN12
Controller stand and
controller holder are
located on the right
armrest.
Place your fingers
in the groove
Hold the legrest with your hands until it
has been set on the floor completely.
If you release the legrest too soon, it
will spring back to the initial position.
●
Pillow
●
Power cord
①
The unit must be carried by two or more
persons.
• Since the unit is heavy, be careful to
avoid back injuries.
Unit weight
②
Watch your step carefully and put down
the unit slowly.
Lay out a mat, etc.
Since the unit may damage the flooring, it is
recommended to place the unit on a mat.
When placing a mat under the unit, the size of
the mat should be sufficient (at least 120 cm ×
70 cm (47.2 in. × 27.6 in.) ) to cover the areas
where the unit touches and where the legrest
could touch the floor.
■ Do not hold the foot part!
The sole massage section might
slide, and injuries may occur.
●
Comfort cushion
Approx. 87 kg
(191.8 lbs)