Setting Up The Unit - Panasonic EP-MS40 Mode D'emploi

SETTING UP THE UNIT

Where to use the unit
Leg/foot massage section
Approx. 15.7" (40 cm)
Depth approx. 42.5" (108 cm)
Width
approx. 27.5"
(70 cm)
Area where the unit and leg/foot
massage section touch the floor
approx. 45.3" (115 cm)
1 Unpack the unit
Inspect contents of shipping container.
Main unit
Controller
7
7-8
• Do not expose the massage lounger to direct sunlight or high
temperatures, such as in front of heating sources, because
this can cause discoloration or hardening of the surface
material.
• Placing a mat or cloth under the unit is recommended to
prevent floor damage. The size of the mat should be sufficient
[at least 25.6 in. × 45.3 in. (65 cm × 115 cm)] to cover the
areas where the unit touches and where the leg/foot massage
section could touch the floor.
• Set the unit near the outlet.
• Position the unit so that the
back is not in contact with any
other object (such contact may
Mat
cause warping and lead to
damage).
See Warning No. 10 and 11 on page 1.
Accessories
Controller Holder Backrest cushion
Lock Switch Key Power cord
• The lock switch key has
been inserted in the lock
switch prior to leaving the
factory.
2 How to move the unit
Since the unit is very heavy [approximately 103.4 lbs (47 kg)], be careful to avoid back injuries. (The unit must be carried by two
people.)
Put the unit down slowly and carefully watch your step.
See Caution No. 13 on page 3.
Lifting the Unit
• You may damage the floor by dropping the unit if you do not hold it correctly.
• Check that the leg/foot massage section is stored away and locked.
Place the controller and power cord on the seat
Leave
a gap
Furniture
etc.
Hold the sides of the Placement area (place a mat
main unit to protect the floor)
Using the wheels to move the unit
Place the controller and power
cord on the seat
Lift it no higher
Mat
than waist height
In narrow corridors etc., hold the front and rear of the
main unit.
Place the controller and power cord
on the seat
Placement area (place a mat
to protect the floor)
At the front
Hold the stiff metal part
within the main unit
Wheels
The hold position is the same
as that shown in "At the front".
Hook your fingers on the
dent under the main unit
8
2010/01/20 13:28:50