Panasonic EP-MS40 Mode D'emploi page 9

USING PRE-PROGRAMS
[Program Selection Mode]
Press the
selection mode for Pre-Programs.
(The power will turn off automatically if no operation is performed within
3 minutes after entering the program selection mode.)
1
Press
Select one of "DEEP", "QUICK (8 min)", "RELAX" and "REFRESH".
2
Select a program and press the
1) Put your head on the backrest.
Massage Head
1
2
2) When the massage heads reach the top, an operation to
determine your approximate shoulder position will begin.
[Shoulder checking operation]
Massage Head
Pre-Programs characteristics
DEEP QUICK (8 min.)
Uses Knead, Soft Shiatsu Based on the DEEP
and Tap actions to loosen up program, this program
the muscles from neck to concentrates on the areas
lower back. which tire easily and is short
Recommended for those at 8 minutes.
with severe stiffness or Recommended for those
who prefer a stimulating who want a spare-time
massage. massage.
15
15-16
button to enter the program
or to select a program.
The mark for the currently selected
program will flash.
button.
The massage heads will
move slowly upwards with
the unit emitting a beeping
sound.
The massage heads slowly
lower while performing a
tapping action. (The frame
of flashes.)
• For some sitting positions,
the massages heads may
temporarily reach a
position near the lower
back.
RELAX REFRESH
Uses less stimulating actions Lowers the massage
to relax your body. intensity gradually and then
Recommended for those raise it to achieve
who want to relax with a refreshment.
gentle massage. Recommended for
switching mood.
3) A double beep and the flashing of
massage heads are being finely adjusted to the shoulder
position.
[Shoulder Position Adjustment Mode]
4) When the shoulder position is matched, press
begin the program.
• The program will begin automatically after 15 seconds if the
is not pressed.
Caution
Keep your head on the backrest
while shoulder position is being
determined.
If the shoulder position cannot be
correctly determined, an error
message (U10) is displayed and
operations are terminated.
To Customize
To adjust program intensity
Press the – + adjustment buttons.
To use the leg/foot massage simultaneously
Press the button.
(See page 23.)
indicate that the
<How to adjust>
Press or to adjust the
position.
[Each press moves the massage heads
approximately 0.6 in. (1.5 cm).]
to
button
Notes
<Target shoulder position>
Too high
Correct position of the massage
head
(The point where the tapping
action should be felt)
Too low
Content of
display
Intensity 1 2 3
Adjustment
2010/01/20
16
13:28:51