Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When you have selected "Neck and shoulders"
The operation to determine your approximate shoulder position will begin.
(See page 15.)
1 A double beep and the flashing of
adjusted to the shoulder position.
[Shoulder Position Adjustment Mode]
<How to adjust>
2 When the shoulder position is matched, press
•
The program will begin automatically after 15 seconds if the
When you have selected "Back and lower back"
The operation to check you are seated (tapping around shoulders) will begin.
When the unit has confirmed that you are seated, the massage heads move to your back or lower back and the program
begins.
Caution
Keep your head on the backrest
until the program starts.
Otherwise an error message
(U10) is displayed and operations
are terminated.
19
19-20
indicate that the massage heads are being finely
Press
or
to adjust the position.
[Each press moves the massage heads approximately 0.6 in.
(1.5 cm).]
to begin the program.
button is not pressed.
To Customize
To adjust program intensity
Press the – + adjustment buttons.
To use the leg/foot massage simultaneously
Press the
button.
(See page 23.)
To change the content of the massage
•
With Self Program, you cannot set a massage longer than the massage time you first set.
If you set a short time by mistake, end the massage, and then press the
To select a different program from Self Program
Press the
button, and select a different program.
Upper body massage will stop temporarily.
(See page 18.)
To change to Pre-Programs
Press the
button and select a program.
Upper body massage will stop temporarily.
(See page 15.)
To change to Manual operation
Press the
button.
Action will start immediately.
(See page 21.)
Content of
display
Intensity
1
2
3
Adjustment
button again and enter new settings.
2010/01/20
20
13:28:52
Publicité
Table des Matières
