Setting Up The Massage Lounger; Checking The Accessories - Panasonic EP-MAF1 Mode D'emploi

Setting up the massage lounger

1) Checking the accessories

●
Pillow
2) Where to use the unit
Ensure there is adequate space to recline.
●
Unit body dimensions Height approx. 120 cm (47.2 in.) × Width* approx. 68 cm (26.8 in.) × Depth* approx. 200 cm (78.7 in.)
(See EN48 for detailed unit dimensions.)
* When installing near a wall, etc.
In the reclining state, make sure that the backrest and the legrest are separated from walls, etc., by 10 cm
(3.9 in.) or more, and the armrest is separated from walls, etc., by 5 cm (2.0 in.) or more.
●
Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of heating sources.
This can cause discoloration or hardening of the synthetic leather.
3) Installing
Two or more persons!!
EN12
●
Lock switch key (1 pc.)
This is initially inserted
in the lock switch of the
power switch section prior
to leaving the factory.
Place your fingers
in the groove
■ Hold the sides of the legrest .
■ Hold the legrest with your
hands until it has been set on
the floor completely .
● If you release the legrest too soon, it
will spring back to the initial position.
●
Comfort cushion
Attached to the main unit
prior to leaving the factory.
●
The unit must be carried by two or more
persons.
• Since the unit is heavy, be careful to
avoid back injuries.
Unit weight
●
Watch your step carefully and put down the
unit slowly.
Lay out a mat, etc .
Since the unit may damage the flooring, it is
recommended to place the unit on a mat.
When placing a mat under the unit, the size of
the mat should be sufficient (at least 120 cm ×
70 cm (47.2 in. × 27.6 in.)) to cover the areas
where the unit touches and where the legrest
could touch the floor.
Do not hold the foot part!
The sole massage section might slide,
and injuries may occur.
●
Sole covers
Approx. 73 kg
(160.9 lbs)