Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Question
During operation
The angle of the backrest, legrest
or armrest automatically changes
at times.
The backrest is not restored to
upright position after massaging.

After use

Red marks are left on the under
side of my hands/arms after a
hand & arm massage.
How to adjust the <Position>
The correct shoulder position
cannot be found during body
scanning of position. (The
shoulder position slips each
time.)
* Body scanning: action of estimating the shoulder position immediately upon startup. (EN22 to EN23)
(continued)
The angle automatically changes in the following cases.
While body scanning
The unit body moves automatically, and gets inclined to the
angle that makes body scanning easy.
● If you have adjusted the reclining before use, the angle will not
change.
Raises
around 60°
When
The chair automatically returns to the upright position.
● Only the legrest returns to the original position if the massage is
completed according to the timer.
● If
is pressed to end the massage, all operations
immediately stop and the angle does not automatically change.
Only the legrest is retracted when the motion comes to stop by
timer operation.
Press
twice to restore the backrest to the upright
position.
Marks may remain on the hands and arms after use.
These eventually fade and are not a problem.
Correct body scanning of shoulder roller position may not be
possible for some sitting positions (such as leaning forward).
Adjust with "▲" and "▼" button.
(EN22 to EN23)
Answer
is pressed to end the massage.
▶Continued on the next page
Reclines
around 20°
EN41

Publicité

Table des Matières
loading

Table des Matières