Inserting The Batteries Into The Training Computer; Use - DS Produkte 01504 Mode D'emploi

EN

Inserting the Batteries into the Training Computer

PLEASE NOTE!
■ Use only the battery type specifi ed in the "Technical Data".
■ Take the batteries out of the training computer when they are dead or if you will not be
using the device for a prolonged period. This avoids damage from leaking.
■ Remove dead batteries from the training computer immediately.
■ Non-rechargeable batteries must not be recharged or reactivated by other means,
dismantled, thrown into a fi re, immersed in fl uids, or short-circuited.
Before inserting the batteries, check whether the contacts in the training computer and
on the batteries are clean, and clean them if necessary.
1. Pull the training computer carefully out of the holder if necessary.
2. Grip and press down the locking lug on the battery compartment cover. Flip open the
cover at the same time.
3. Insert the supplied batteries or new batteries into the battery compartment. Pay atten-
tion to the correct polarity (+/–).
4. Close the battery compartment. When you do this, make sure that the locking lugs sit
in the recesses which are provided for them. The battery compartment cover must be
heard to engage in place.
5. Insert the training computer back into the holder.
If the training computer stops working, the battery needs to be replaced.

Use

PLEASE NOTE!
■ When doing the exercises, wear loose, comfortable clothing and non-slip trainers.
■ Ensure that you are properly warmed up before you use the training device.
■ Never stand on the training device.
■ Do not leave the training device unsupervised in the presence of children and ani-
mals.
■ We explicitly point out that improper use of the training device and excessive training
can be detrimental to your health.
18
10. Turn the pedals tight on the pedal mounts using the span-
ner. Make sure that the markings L (left) and R (right) on
the pedals and mounts match.
PLEASE NOTE: The pedals must be tightened in the
direction of travel. This means:
– the right pedal (right-hand thread) is tightened in the
clockwise direction,
– the left pedal (left-hand thread) is tightened in the
anticlockwise direction.