Assembling The Training Device - DS Produkte 01504 Mode D'emploi

Assembling the Training Device

Read through the assembly instructions carefully before assembling the train-
ing device. The sequence of working steps described must be followed ex-
actly.
1. Carefully open up the training device, and release the locking pin to do this if neces-
sary.
2. Lay out all individual parts carefully on a fl at fl oor.
PLEASE NOTE: Protect the fl oor, carpet etc. with a mat or something similar before
the component parts are removed from the box and also during set-up and training.
17
3. Screw the feet onto the bottom of the bicycle frame. Use
the corresponding bolts, washers and nuts to do this.
Make sure that the feet are placed in the correct po-
sition! The cap nuts must not be attached from below as
otherwise the training device is not able to stand securely
on the fl oor.
Notice: The protective caps can be turned so that you can
adjust the training device to a stable position.
4. Place the saddle onto the saddle holder and screw it on
tight using the washers and the self-locking nuts. When
you do this, make sure that they can only be tightened and
undone again using a tool.
5. Place the saddle holder into the receiving socket on the
bicycle frame. Secure it in place using the adjusting knob:
Align the holes on the frame and the holder with one an-
other and turn the adjusting knob clockwise to tighten it.
Notice: The saddle can be adjusted to the correct height
after assembly.
6. Screw the handlebar onto the bicycle frame. Use the cor-
responding hexagon bolts and washers to do this.
7. Secure the computer holder to the handlebar by placing
it on the handlebar and securing it on tight with the corre-
sponding bolts and washers.
8. Slide the training computer onto the computer holder.
9. Insert the jack plug from the bicycle frame into the con-
necting socket on the training computer. This connects the
computer sensor to the pedals.
EN