Preparing The Device For Use - DS Produkte TS-21927 Mode D'emploi

EN

Preparing the Device for Use

PLEASE NOTE!
■ Only connect the device to a plug socket that is properly installed and matches the
technical data of the device. The plug socket must also be readily accessible after
connection so that the connection to the mains can quickly be isolated.
■ Lay the connecting cable in such a way that it does not become crushed or kinked
and does not come into contact with hot surfaces.
1. Place the device on a dry, even and fi rm surface. If the device is used on a carpet,
make sure that the ventilation openings on the bottom of the device remain clear.
Protect sensitive fl oor coverings on which the device is placed with a mat if
necessary.
2 m 2 m
1 - 1.6 m m
1 m 1 m
2. First connect the connecting cable to the socket (8) of the device and then to a prop-
erly installed, easily accessible plug socket.
Attaching / Detaching Expander Bands
Attach the expander bands to the device for advanced exercises for the muscles in your
upper body, e. g biceps or triceps curls.
IMPORTANT! If the expander bands are not being used, always take them off and fold
in the plates with the eyelets.
18
Depending on your body size, leave plenty
of space on all sides of the training device
(at least 1 metre to the sides, 2 metres above)
so that you have enough room to move about
in during a workout. Furthermore, the free area
in the direction from which you access the train-
ing device must be at least 0.6 m greater than
the exercise area. The free area must include
the space required for an emergency dismount.
If training devices are set up in the immediate
1 - 1.6 m vicinity of one another, they can share one free
area.
1 - 1.6 m
1. Turn over the device so that the bottom is pointing
upwards. On the front feet (4) of the device there are
two plates with eyelets (2).
2. Turn the plates with the eyelets to the front so that
they protrude.
3. Hook the snap hooks of the expander bands into the
eyelets.
4. Then place the device back on its feet.
The expander bands are detached in the reverse order.