Installing The Wood Or Pebbles Set; Final Inspection; Flame Image; Operating The Heating Module - Dru Verwarming METRO 80E Manuel D'installation Et D'entretien

INSTALLATION AND SERVICE MANUAL
support strips (6);
11. Carefully lift the glass sheet (4) slightly and rest it on the
top support strips (5);
12. Install the left (2) and the right (3) decorative profi le;
13. Install the air inlet profi le (1).
8. Installing the wood/pebbles set
Installing the wood set:
It would be preferable to position the wood trunks as
shown in Fig. H. This is however not a requirement, and a
different position is always possible and will only affect the
fl ame image produced by your appliance.
Heating bed
Installing the pebbles set:
You may place the pebbles anywhere on the base plate. Fig.
I presents an example.
Heating bed
463385-D84-03-NL.indd Sec1:6 463385-D84-03-NL.indd Sec1:6
12
Figure G
Figure H
Figure I

9. Final inspection

9.1

Flame image

- Connect the mains cable to the wall socket outlet;
- Start the appliance with the switch on the top right of
the appliance;
- Check whether the fl ame image is visible;
- Use the remote control to check whether the intensity
of the fl ame image responds to the remote control (see
Section 11 – Remote Control).
9.2

Operating the heating module

- Switch on the heating element with the remote control
(see Section 11 – Remote Control);
- Check whether the heat is blown from the grill;
7
- Check whether both the heat positions can be switched
on and off with the remote control.

10. Maintenance

10.1 General

Your appliance should be inspected each year by a duly
qualifi ed company. The annual inspection should focus on
the following points:
- Dust accumulation in the appliance
- Accumulation of dust in the fan and the heating element
- Quality of the earthing connection
Keep in mind the following aspects during maintenance:
1. First remove the plug from the socket outlet;
2. Ensure that the electronic devices are not damaged by
static electricity;
3. Before commencing maintenance operations, make sure
that the appliance has cooled down and that the
appliance is voltage-free.
4.Only original parkers may be used since they
provide the appliance with earthing. Carefully
store all the original parkers during dismantling.
If any parkers are left out during installation,
there is no guarantee of proper earthing.
If necessary, the air inlet and the air outlet may be cleaned
with a vacuum cleaner and a soft brush, but before com-
mencing cleaning, ensure that the appliance is voltage-free.
Never touch the fan with hard parts, this may cause imba-
lances.
Dust may accumulate on the inside of the front glass frame
in the course of time. You may remove this dust with a glass
cleaner or a wet cloth (see procedure for removing
the glass sheet).
Do not use any abrasive or caustic materials to clean the
appliance. The guarantee does not cover damage to paint,
for example due to objects being placed on or against the
appliance.
6
07-12-2007 11:09:35 07-12-2007 11:09:35