Switching Off The Device - TechniSat DIGITRADIO 2 Mode D'emploi

5.4.2 Switching off the device

With mains operation:
> By briefly pressing the On / Standby button you can switch the device to
standby mode. [Standby] appears briefly on the display. The date and time are
shown on the display. The display brightness in standby mode can be adjusted
by following the instructions in Section 12.2.
> Pressing and holding the On / Standby button will put the device in power-
saving mode and the display will go off. [Power off] appears briefly on the
display.
The battery will also charge in standby or low power mode.
In battery mode
> In battery mode, the unit is always switched off by pressing the On / Standby
button. [Power off] appears briefly on the display. In this case, there is no date
and time display.
Standby mode is not available on battery power.
DE
EN
FR
IT
NL
PL
CZ
105