General Device Functions; Switching On The Device; Switching Off The Device; Source Selection - TechniSat Techniradio 5 IR Mode D'emploi

Masquer les pouces Voir aussi pour Techniradio 5 IR:

Table des Matières

Les langues disponibles

4.4 General device functions

Switch on the TECHNIRADIO 5 IR by pressing the Power button (1).

After switching on the device for the first time, you must first set the

[Language]. To do this, select one of the available languages by turning the

Scroll&Select/Snooze knob, then press the Scroll&Select/Snooze knob to

confirm the selection. You can then launch the initial set-up wizard. Do this

by selecting Yes using the Scroll&Select knob. Here you can set the date

and time either via DAB/FM, Internet or no update (manual). An attempt is

then made to establish a connection to a WLAN network. To do so, select the

corresponding WiFi network and, if required, enter the WiFi password.

By briefly pressing the Power button you can switch the device to standby

mode. The date and time are shown on the display. The display brightness in

standby mode can be adjusted by following the instructions in Section 12.4.

Press the MODE button (2) to switch between DAB+ (Digital Radio), FM,

Internet radio/music playback and Aux In sources. Press the button

repeatedly to do so.

Alternatively:

Hold down the Menu/Info button until the main menu opens.

Use the Scroll&Select/Snooze knob to select the [Mode Selection] item,

then press the Scroll&Select knob.

Use the Scroll&Select knob to select the source you want, then confirm your

selection by pressing the Scroll&Select knob.

Adjust the volume using the Volume knob. Turning to the right increases the

volume; turning to the left reduces it.

The set volume is shown on the display by way of a bar chart.

Table des Matières

Table des Matières