Troubleshooting - TechniSat Techniradio 5 IR Mode D'emploi

14 Troubleshooting

Symptom
No radio station is being received.
No DAB signal is being received.
The sound is weak or of
poor quality.
The device cannot be switched on.
No sound can be heard.
Distorted sound can be heard.
Other operational malfunctions occur,
such as loud noises or a malfunctioning
display.
The display does not switch on.
Possible cause/remedy
The device is not currently in radio
mode. Press the MODE button.
Check whether DAB reception is possible
in your region. Readjust the antenna.
Try to receive other stations.
Other devices such as televisions are
disrupting reception. Move the unit
further away from these devices.
The antenna is not extended or
correctly orientated. Extend the
antenna. Rotate the antenna to improve
reception.
Check the mains adapter.
Increase the volume. Remove the
headphone jack from the device if
you want to listen via the speaker. It
is possible that the wrong source was
selected.
In the vicinity of the device, a
mobile phone or other device
is emitting disruptive radio waves.
Remove the mobile phone or device
from the vicinity of the radio.
Electronic device components are
faulty. Remove the mains plug. Leave
the device disconnected from the
power source for approx. 10 seconds.
Reconnect
the device.
Switch the device off. Remove the mains
plug,
reinsert it and switch the device on.
Check the display brightness setting.
PL
63