Set-Up Wizard; Backlight - TechniSat Techniradio 5 IR Mode D'emploi

You can also use the WPS function in the network wizard. To do this first
select a WiFi network and then select the Press Button or PIN option. You can
otherwise use Skip WPS to reach manual password entry.
To find out more about the current connection select Settings.
Select Manual setting, if you know your network parameters and would like to
configure them manually. Take note of the instructions on the display.
Select Delete network profile to delete connections no longer required.
If the network connection should be retained in standby, select Enable
Network Connection in Standby > Yes. However, doing so will increase the
power consumption.

12.3 Set-up wizard

On first switching on and after a factory settings reset, the set-up wizard is
automatically launched.
> First select the Display Language and then > YES as soon as Perform now is
shown on the display.
If you select No, the wizard closes and you must perform the required settings
manually.
You will be taken through the settings in various steps.
> Under Time format, select the desired display format for the time display
(Section 12.1.3).
> During the next step you must select via which source the time is to be
synchronised (for more information refer to Section 12.1.2).
> You can then set up a WiFi network connection. For more details, see Section
12.2.
> Press the Scroll&Select/Snooze knob to close the wizard when Set-up
Wizard Completed appears in the display.

12.4 Backlight

Under System settings > Backlight you can adjust the brightness of the display
for Operation and for Standby . You can choose between High, Medium and Low.
Confirm the selection by pressing the Scroll&Select/Snooze knob. Under Auto Dim
you can set the time after which the display is automatically dimmed.
PL
61