Language; Factory Settings; Software Update; Set-Up Wizard - TechniSat DIGITRADIO 370 CD IR Mode D'emploi

16.6 Language

Press the MENU button and use the / buttons to select the [System
>
Settings] > [Language] item, then press ENTER.
Use / to select one of the available languages and confirm by pressing the
>
ENTER button.

16.7 Factory settings

If you change the location of the device, e.g. when moving house, it is possible that
the saved stations can no longer be received. In this case you can reset the device to
factory settings to delete all the saved stations and launch a new scan.
Press the MENU button and use the / buttons to select the [System
>
Settings] > [Factory Settings] item, then press ENTER.
Use / to select the [Yes] option, then press ENTER to reset to the factory
>
settings.
All previously stored stations and settings will now be deleted. The device is
now in the same status as when delivered.
> [Restarting...] appears on the display.
The device will switch to standby after successfully resetting to the factory
settings. You will then need to run the initial installation wizard.

16.8 Software update

The Software Update feature is used to update the device software.
Press the MENU button and use the / buttons to select the [System
>
Settings] > [Software Update] item, then press ENTER.
Auto update
> Enable this function so that the DIGITRADIO 370/371 CD IR automatically
searches for new software versions during operation. If new software is found,
a note will appear in the display. Note the information on the screen and do
not switch the device off during the software update.
Check now
> Select [Check Now] to launch an immediate search for a new software version
on the Internet. Note the information on the screen and do not switch the
device off during the software update.

16.9 Set-up wizard

Here the initial set-up wizard can be accessed again. For more details, see Section „6
Ersteinrichtung" auf Seite 62.
DE
EN
FR
NL
83