Troubleshooting - TechniSat DIGITRADIO 2 Mode D'emploi

Only clean the display with a soft, cotton cloth. If required, use a cotton cloth with
small amounts of non-alkaline, diluted, water or alcohol-based soap solution.
Gently clean the surface using the cotton cloth.

14 Troubleshooting

If the device does not operate as intended, check the following table for information.
Symptom
The device cannot be switched on. The device is not being supplied with power.
No sound can be heard.
The display does not switch on.
Poor reception via DAB+/FM.
134
Possible cause/remedy
Connect the power supply unit correctly to the
socket and to the device. Charge the battery.
Increase the volume.
Disconnect the device from the mains supply,
remove the battery and reconnect the device to
the mains.
Extend the antenna. Change the position of the
antenna or the DIGITRADIO.