General Device Functions; Switching On The Device; Switching Off The Device - TechniSat DIGITRADIO 10 IR Mode D'emploi

6.4 General device functions

6.4.1 Switching on the device

> First prepare the DIGITRADIO 10 IR for operation as described in Sections 6.3.1
and 6.3.4.
> Press the On/Standby button (18) on the remote control to turn on the
DIGITRADIO 10 IR.
After switching on the device for the first time, you must first configure the
first installation wizard. There are details of this in Section 8.

6.4.2 Switching off the device

> By briefly pressing the On / Standby button you can switch the device to
standby mode. [Standby] appears briefly on the display. The date and time
are shown on the display. The display brightness in standby mode can be
adjusted by following the instructions in Section 16.3.
DE
EN
NL
FR
105