Horizon Hobby HANGAR 9 Ultra Stick 10cc Manuel D'utilisation page 23

 RADIO INSTALLATION (OPTION 2)
108. Attach the control horn to the top of the elevator using
the technique outlined for the aileron servos. Use three
M2 x 15 screws and nuts along with the control horn
backplate.
 Make sure to apply a drop of canopy glue in the
threads of each nut to prevent them from vibrating loose.
109. Attach the control horn to the rudder, opposite the
elevator horn, using the technique outlined for the aileron
servos. Use three M2 x 15 screws and nuts along with
the control horn backplate.
 Make sure to apply a drop of canopy glue in the
threads each nut to prevent them from vibrating loose.
110. Connect a 9-inch (230mm) extension to the elevator
servo. Remove the covering using a hobby knife and #11
blade. Mount the elevator servo in the fuselage with the
output facing toward the front of the fuselage.
 Make sure to prepare the servo screw holes
with thin CA prior to installing the servos.
111. Thread an M3 nut on one end of the 6-inch (152mm)
pushrod. Slide a clevis retainer (silicone tubing) on a
metal clevis, then thread the clevis on the rod. Repeat so
there are clevises on both ends of the pushrod.
112. Center the elevator servo and install the servo arm
perpendicular to the servo centerline. Adjust the linkage
so the elevator is centered when the servo is centered.
Tighten the nut against the clevis, then slide the clevis
retainer (silicone tubing) over the forks of the clevis. Use
threadlock on the nut to prevent it from vibrating loose.
™
Ultra Stick 10cc
108.
109.
110.
111.
112.
113. Repeat the above steps to build and install the rudder
1
pushrod. Use the included 8 / -inch (210mm) pushrod for
4
the rudder in this step.
 LANDING GEAR INSTALLATION
 Optional floats are available for your model. The
float installation is covered later in this manual.
114. Attach the axle to the landing gear using the nut supplied
with the axle. With the fl at areas of the axle facing down,
tighten the axle using two 1/2-inch wrenches. Secure the
wheel collar to the axle using a 1.5mm hex wrench.
115. Place a drop of light machine oil on the axle, then slide
the wheel on the axle. Position the wheel collar fl ush with
the end of the axle. Secure the wheel using a 5/32-inch
wheel collar, tightening the setscrew on the outer fl at
area. Make sure to use threadlock on the setscrew to
prevent it from vibrating loose.
116. Check that the M4 x 20 socket head cap screws thread
easily into the blind nuts. If not, use a 4mm tap to clear
the threads of the blind nuts so the screw threads in
easily.
117. Position the gear on the bottom of the fuselage. Attach
the gear to the fuselage using three M4 x 20 socket head
cap screws and three M4 washers. Use threadlock on
the screws.
23
113.
114.
115.
116.
117.
EN