Horizon Hobby HANGAR 9 Ultra Stick 10cc Manuel D'utilisation page 21

89. Lightly sand the tail wheel wire where it contacts the
rudder. Use a paper towel and isopropyl alcohol to
remove any oil or debris from the wire.
90. Mix a small amount of 15-minute epoxy. Use a toothpick
to apply epoxy to the rudder where the tail wheel wire
will come in contact with the exposed wood.
91. Use a toothpick to apply epoxy to the tail wheel wire
where it contacts the rudder.
92. Fit the wire into the rudder. Use a paper towel and
isopropyl alcohol to remove any excess epoxy from the
rudder and wire.
93. Use low-tack tape to hold the tail wheel wire in position
until the epoxy fully cures. Once cured, remove the tape
from the rudder.
™
Ultra Stick 10cc
89.
90.
91.
92.
93.
94. Prepare the hinge slots and hinges for the rudder. Install
the hinges and fi t the rudder to the fi n. Align the top of
the fi n and rudder. Use thin CA to glue the hinges. Once
the CA cures, gently pull on the fi xed surface and control
surface to make sure the hinges are glued securely. If
not, apply additional CA to secure each of the hinges.
95. Position the tail wheel bracket so it is centered on the
bottom of the stabilizer. Use a felt-tipped pen to mark the
location for the mounting screws. Use a drill and 1/16-
inch (1.5mm) drill bit to drill the holes for the screws.
96. Use a #1 Phillips screwdriver to thread the M2.5 x 10
self-tapping screws into the holes. Remove the screws,
then apply thin CA into the holes to harden the threads.
Once the CA has fully cured, install the three screws to
secure the tail wheel bracket to the stabilizer.
97. Slide the wheel collar against the tail wheel bracket and
tighten the setscrew using a 1.5mm hex wrench.
98. Attach the tail wheel to the wire using a 3mm wheel
collar and 3mm setscrew. Apply threadlock to the
setscrew, then tighten the setscrew using a 1.5mm hex
wrench.
 Use the foam tail wheel for quieter operation when
using EP (electric power) systems, or from asphalt
runways. Use the rubber tail wheel for grass runways.
21
94.
95.
96.
97.
98.
EN