Horizon Hobby HANGAR 9 Ultra Stick 10cc Manuel D'utilisation page 18

59. Use an epoxy brush to apply epoxy to the stabilizer
mounting surface in the notch in the fuselage for the
stabilizer.
60. Fit the stabilizer back into position. Check the alignment
following steps 1 through 3, then use a paper towel and
isopropyl alcohol to remove any excess epoxy from the
fuselage and stabilizer.
61. Use clamps to hold the stabilizer in position. Allow the
epoxy to fully cure before proceeding.
 FIN INSTALLATION
62. Fit the fi n into the slot in the fuselage. Use a ruler to
check the alignment of the fi n to the rear edge of the
fuselage.
63. Use a felt-tipped pen to trace the outline of the fi n on the
top of the fuselage. Also mark the bottom of the fi n along
the fuselage.
EN
59.
60.
61.
62.
63.
64. Use a hobby knife with a #11 blade to carefully remove
the covering 1/8-inch (3mm) inside the lines drawn from
the top of the fuselage at the rear of the fi n.
65. Use a hobby knife with a #11 blade to carefully remove
the covering 1/8-inch (3mm) inside the lines drawn from
the top of the fuselage at the front of the fi n.
66. Use a ruler and carefully cut the covering 1/8 inch (3
mm) below the line drawn on the fi n. Remove the bottom
covering. Use care not to cut into the underlying wood,
weakening the fi n. Apply a small amount of thin CA along
the edge of the covering to strengthen the area under the
covering in case the knife has penetrated to underlying
wood.
67. Mix 1/2 ounce (15ml) of 30-minute epoxy. Use an epoxy
brush to apply the epoxy in the slot for the fi n and to the
exposed wood on the top of the fuselage.
68. Apply epoxy to the exposed wood on the bottom of the
fi n where it comes in contact with the fuselage.
18
64.
65.
66.
67.
68.