Horizon Hobby HANGAR 9 Ultra Stick 10cc Manuel D'utilisation page 13

11. Install all three aileron hinges at this time.
12. Repeat the previous steps to install all three of the fl ap
hinges.
13. Fit the aileron and fl ap to the wing by inserting the
hinges into the slots in the wing.
14. Check that there is a slight gap between the wing and
the end of the aileron. Use a thin ruler (or similar) that is
1/16-inch (1.5mm) thick as a spacer so both the ailerons
have the same size gap. Remove the T-pins from the
aileron hinges.
15. Apply thin CA to the top and bottom of each hinge. Once
the CA cures, gently pull on the fi xed surface and control
surface to make sure the hinges are glued securely. If
not, apply additional CA to secure each of the hinges.
™
Ultra Stick 10cc
11.
12.
13.
14.
15.
16. Check the gap between the fl ap and aileron. Use a thin
ruler (or similar) that is 1/16-inch (1.5mm) thick as a
spacer so the gap between the ailerons and fl aps are
the same. Remove the T-pins and glue the hinges for the
fl aps using thin CA.
17. Once the CA cures, gently pull on the fi xed surface
and control surface to make sure the hinges are glued
securely. If not, apply additional CA to secure each of the
hinges.
18. Flex the fl ap and aileron through their range of motion a
few times to break in the hinges.
 AILERON AND FLAP SERVO INSTALLATION
19. Remove the aileron servo hatch from the wing. Make
sure to keep the string taped to the wing so it doesn't fall
into the wing.
13
16.
17.
18.
19.
EN