Horizon Hobby HANGAR 9 Ultra Stick 10cc Manuel D'utilisation page 14

20. Use a hobby knife and #11 blade to remove the covering
in the servo cover to the servo arm.
21. Check that the servo mount is glued securely to the
servo cover. If the mount is not secure, use a small
amount of medium CA or epoxy to make sure the mount
is securely fastened to the servo cover.
22. Use a toothpick to puncture the covering to locate the
holes for the aileron and fl ap cover screws.
23. Use a pin vise and 5/64-inch (2mm) drill bit to drill the
holes in the servo cover mounts.
24. Thread an M3 x 10 self-tapping screw into each of the
holes in the aileron and fl ap servo cover mounting holes.
Remove the screws before proceeding.
 Make sure not to apply excessive downward
pressure which could result in damage to the wing.
EN
20.
21.
22.
23.
24.
25. Apply a small amount of thin CA to harden the threads
made in the previous step. Allow the CA to fully cure
before installing the aileron servo cover.
26. Install the grommets and eyelets in the servos. Follow
any instructions included with the servo. Prepare both
fl ap and aileron servos at this time.
27. Fit the servo between the servo mounting tabs in the
aileron servo tray. The servo arm will be centered in the
slot. Mark the locations for the servo mounting screws
using a pencil, then remove the servo.
28. Use a drill and a 5/64-inch (2mm) drill bit to drill the
holes for the servo mounting screws in the locations
marked in the previous step. Use a 2mm hex wrench to
thread a servo mounting screw into each of the holes in
the aileron servo mounting holes. Remove the screws,
then apply a small amount of thin CA to harden the
threads.
29. Center the aileron servos using the radio system. Prepare
both aileron servos at this time. The output of the servo
arms will mirror each other so the ailerons work in
opposite directions. Use side cutters to remove any
unused arm so they don't interfere with the operation of
the servo.
14
25.
26.
27.
28.
29.