Horizon Hobby HANGAR 9 Ultra Stick 10cc Manuel D'utilisation page 12

 AILERON AND FLAP INSTALLATION
1. Remove the aileron and fl ap from the wing.
2. Use a 5/64-inch (2mm) drill bit to clear the holes of any
debris for the control horn mounting screws.
3. Use a hobby knife to separate the control horn backplate
from the control horn.
4. Insert the three M2 x 25 machine screws into the holes
of the control horn, then into the holes in the aileron.
Make sure the control horn is installed on the bottom of
the aileron.
5. Slide the control horn backplate on the screws. Apply
a small amount of canopy glue on the screws using a
toothpick, then thread the M2 nuts on the screws. Use
a #1 Phillips screwdriver and 4mm nut driver to tighten
the screws.
 The holes in the control horn backplate are sized
to allow the screw to pass through them. The nuts
must be used to properly secure the control horns
to the control surface. Failure to secure the control
horns with the included nuts will result in the control
horns not being secure on the control surface.
EN
1.
2.
3.
4.
5.
6. Use side cutters to trim the screws.
7. Use a fi le to lightly fi le any sharp points from the screws
after they have been trimmed. Use care not to contact
the control surface with the fi le.
 Prepare and install the flap control horns at this time
following the same procedure as the aileron control horns.
 Make sure to drill the hole for the hinges.
The hole provides a tunnel for the CA to fully
wick into the hinge. Not drilling this hole may
result in hinges that are not properly glued.
8. Remove the hinges from the aileron and fl ap. Use a pin
vise and 1/16-inch (1.5mm) drill bit to drill a hole in the
center of each hinge slot to allow the CA to wick into the
hinge. Drill holes in both the wing and control surfaces
at this time. The ailerons and fl aps can both be prepared
during this step.
9. Place a T-pin in the center of each hinge.
10. Slide the hinges into position in the aileron with the T-pin
resting against the edge of the control surface.
12
6.
7.
8.
9.
10.