Fitting The Standard Transmitter On The Taper With Adjusting Flange - marposs E86N Manuel D'installation Et D'utilisation

12.2

Fitting the Standard transmitter on the taper with adjusting flange

1. Remove the transmitter battery covers by taking out the screws (see section 12.1).
Note: The operations described in points 2 - 3 - 4 and 5 only apply to a transmitter with radio activation. A transmitter with
mechanical activation (microswitch on taper) is supplied, complete with tool taper, with adjusting flanges already
fitted. In the latter case, proceed from point 6.
2- Remove the standard flange (C) from the transmitter by taking out the four screws (D).
3- Secure the adjusting flange (E) to the transmitter with the four screws (D).
Figure 12-2
4. Make two threaded holes M4x8 (F) in the tool taper.
5. Secure the adjusting flange (G) to the tool taper with the two screws (H).
Note: To facilitate transmitter LED (L) angling towards the operator, there are three pairs of fixing holes, allowing you to
select the most suitable angle.
6. Join the two units (transmitter and tool taper), aligning the four threaded holes (M) in the taper flange (G) with the four slots (N) in
the transmitter flange (E).
7. Insert the four threaded stud bolts (P) in the slots (N) and tighten them in the threaded holes (M) in the taper flange with the
hexagon wrench supplied.
8. Tighten the four special nuts (Q) on the stud bolts.
Figure 12-3
mida
D
E
D
C
F
M
G
N
E
P
Q
L
G
H
H
F=M4x8
83